StarDot NetCam SC Box Camera driver for Windows 7 - StarDot NetCam SC Box Camera driver from StarDot

StarDot NetCam SC Box Camera 1.1.80

StarDot NetCam SC Box Camera driver from StarDot for OS Independent

StarDot NetCam SC Box Camera driver from StarDot for OS Independent

Publisher review for StarDot NetCam SC Box Camera 1.1.80:

Before install StarDot NetCam SC Box Camera 1.1.80you should set a system restore point, to make sure you can rollback to your original driver in case you accidentally install another driver or select the driver for another version of the operating system.

Also, do not forget to check with our site as often as possible for new version of StarDot NetCam SC Box Camera . We recommend to always use most recent version of a driver.

Multi-Megapixel Hybrid IP Camera
Full featured Multi-Megapixel IP Video doesn't have to be expensive and it doesn't have to be an IP-only solution. StarDot's new NetCam SC gives you the best of both worlds in a compact and easy to configure package. Although the SC5 boasts a whopping 5 megapixel image sensor, it can be run at lower resolutions, including HD (1080P & 720P), portrait and widescreen modes.NOTE for h.264 cameras You MUST clear the configuration files during the upgrade to 1.1.78 or the H.264 video will not be enabled. Using StarDot Tools, you can clear the configuration files while retaining the network settings.
WARNING: Firmware on this page is only compatible with camera IDs (MAC address) that begin with:

h.264 box cameras:
00:30:F4:E6
00:30:F4:E7
00:30:F4:E8
00:30:F4:E9
00:30:F4:EA
00:30:F4:F0

mjpeg cameras:
00:30:F4:D0
00:30:F4:D1
00:30:F4:D2
00:30:F4:D3
00:30:F4:D5 - DO NOT USE THIS VERSION OF FIRMWARE FOR THIS CAMERA. USE 1.1.75 OR BELOW
00:30:F4:E0
00:30:F4:E1
00:30:F4:E2 - DO NOT USE THIS VERSION OF FIRMWARE FOR THIS CAMERA. USE 1.1.75 OR BELOW
00:30:F4:E4
00:30:F4:E5

If this firmware is used with any other StarDot device, it can leave the device inoperable.

Operating system:
OS Independent